Hello,

I have problem with devices connected to Linksys bridge. The bridge is connected to WLAN on WLC, the bridge MAC address is on client list.

Device connected to LAN port on the bridge can not connect to network but the bridge IP address is accessible.

When I connected PC to th bridge LAN port, PC can connect to network but the bridge is no accessible. On WLC client list is the MAC address of the bridge but details of this association show PC IP address not the bridge Linksys (shown below on picture).

But device connected to bridge operate fine when AP was in autonomous mode without controller. When WLC was added to network all AP are migrated to lightweight mode and the problem above arise.

All network is with /16 bit mask and there is no any L3 device (without WLC).