Dial back up on an 891

Unanswered Question
May 17th, 2010
User Badges:

Hi There,


I am currently reviewing the 891 Router as a replacement for my 1811's in the field, but I am running into a problem with the dialer interface not working properly.


I've used what is essentially the same config from my 1811, and it works if I copy the config over line-by-line (the dialer binds, and I get a solid connection to my VPN), until I restart the router. At this point i get the errors


%Remove Dialer Profile Configuration first


%Warning:Use P2P interface for routemapset

                           interface clause


C

% Incomplete command


C

% Incomplete command


I seem to be at a loss for what this means, can someone help me out?


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Mon, 05/17/2010 - 23:03
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

Hi There,


I am currently reviewing the 891 Router as a replacement for my 1811's in the field, but I am running into a problem with the dialer interface not working properly.


I've used what is essentially the same config from my 1811, and it works if I copy the config over line-by-line (the dialer binds, and I get a solid connection to my VPN), until I restart the router. At this point i get the errors


%Remove Dialer Profile Configuration first


%Warning:Use P2P interface for routemapset

                           interface clause


C

% Incomplete command


C

% Incomplete command


I seem to be at a loss for what this means, can someone help me out?


Thanks

Check out the below link for configuration of dailer list in cisco 860,880 and 890 series routers


http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/routconf.html


Hope to Help !!


Ganesh.H


Remember to rate the helpful post

Actions

This Discussion

Related Content