Hi There,
I
am currently reviewing the 891 Router as a replacement for my 1811's in
the field, but I am running into a problem with the dialer interface
not working properly.
I've
used what is essentially the same config from my 1811, and it works if
I copy the config over line-by-line (the dialer binds, and I get a
solid connection to my VPN), until I restart the router. At this point
i get the errors
%Remove Dialer Profile Configuration first 
%Warning:Use P2P interface for routemapset
                           interface clause
C
% Incomplete command
C
% Incomplete command
I seem to be at a loss for what this means, can someone help me out?
Thanks

Check out the below link for configuration of dailer list in cisco 860,880 and 890 series routers

http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/routconf.html

Hope to Help !!

Ganesh.H

Remember to rate the helpful post