Out of Band remote management dial in access

Unanswered Question
May 18th, 2010

I have a cisco 2821 router with a WIC-1AM card in it.  The router recognizes it ( ie it shows up as an async interface).

Could someone please point me towards a configuration guide or example that would show me how to configure this for  remote access?

The end goal of this is if the internet circuit goes down I can dial into the router to see if it is a router issue and make changes as necessary.

There will be a POTS line connected to the wic card and I have a phone number for the card.

Thank you


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion