CME forward call

Answered Question
May 18th, 2010
User Badges:


Hi guys,


is there any way for CME to forward the destination number to the next CME


for example


SiteB--------SiteC

|        Fa

|

|WAN (se)

|

|

SiteA



siteA number 1000

siteB number 2000

siteC number 3000


3 sites (A, B and C), from siteA I would like to call siteC.

However, on siteA's CME I bind the session target with SiteB's IP and siteB will forward the call to siteC


the config so far more less like below


SiteA

dial-peer voice 2000 voip

destination-pattern 2000

session target ipv4:RouterB

codec g711alaw


dial-peer voice 3000 voip

destination-pattern 3000

session target ipv4:RouterB

codec g711alaw


SiteB

dial-peer voice 1000 voip

destination-pattern 1000

session target ipv4:RouterA

codec g711alaw


dial-peer voice 3000 voip

destination-pattern 3000

session target ipv4:RouterC

codec g711alaw


dial-peer voice 1 voip

incoming called-number .

codec g711alaw


I think that the command "incoming called-number ." will do the trick, but it still doesn't work.

Again I assume that it will be similar config as pots

dial-peer voice <tag> pots

incoming called-number .

direct-inward-dial

port 0/0/0:00


Please advice


Thanks in advance,

Terrence

Correct Answer by Abu Hadee about 7 years 1 month ago

You need to have following command on SiteB Router


Configure terminal

voice service voip

  allow-connection h323 to h323

!


Hope this helps


Thanks

- abu

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Abu Hadee Wed, 05/19/2010 - 03:42
User Badges:
  • Silver, 250 points or more

You need to have following command on SiteB Router


Configure terminal

voice service voip

  allow-connection h323 to h323

!


Hope this helps


Thanks

- abu

vip80y_cisco Wed, 05/19/2010 - 04:35
User Badges:

Thanks abu, it's worked !!

really appreciate your help


Again. thanks heaps

Actions

This Discussion