05-18-2010 11:36 PM - edited 03-15-2019 10:49 PM
Hi guys,
is there any way for CME to forward the destination number to the next CME
for example
SiteB--------SiteC
| Fa
|
|WAN (se)
|
|
SiteA
siteA number 1000
siteB number 2000
siteC number 3000
3 sites (A, B and C), from siteA I would like to call siteC.
However, on siteA's CME I bind the session target with SiteB's IP and siteB will forward the call to siteC
the config so far more less like below
SiteA
dial-peer voice 2000 voip
destination-pattern 2000
session target ipv4:RouterB
codec g711alaw
dial-peer voice 3000 voip
destination-pattern 3000
session target ipv4:RouterB
codec g711alaw
SiteB
dial-peer voice 1000 voip
destination-pattern 1000
session target ipv4:RouterA
codec g711alaw
dial-peer voice 3000 voip
destination-pattern 3000
session target ipv4:RouterC
codec g711alaw
dial-peer voice 1 voip
incoming called-number .
codec g711alaw
I think that the command "incoming called-number ." will do the trick, but it still doesn't work.
Again I assume that it will be similar config as pots
dial-peer voice <tag> pots
incoming called-number .
direct-inward-dial
port 0/0/0:00
Please advice
Thanks in advance,
Terrence
Solved! Go to Solution.
05-19-2010 03:42 AM
You need to have following command on SiteB Router
Configure terminal
voice service voip
allow-connection h323 to h323
!
Hope this helps
Thanks
- abu
05-19-2010 03:42 AM
You need to have following command on SiteB Router
Configure terminal
voice service voip
allow-connection h323 to h323
!
Hope this helps
Thanks
- abu
05-19-2010 04:35 AM
Thanks abu, it's worked !!
really appreciate your help
Again. thanks heaps
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: