Cisco ACS config file

Answered Question
May 19th, 2010
User Badges:

Hi all,


I have a cisco ACS V.4.0 server and want to get the config file. How can I get the CLI command prompt ? Or, Any where I can get the config file ?


Thanks


Leung Che Man

Correct Answer by Jatin Katyal about 7 years 1 week ago

Unfortunately, that is not supported. You've to connect to ACS via hyperterminal using console cable.


Regds,

JK


Do rate helpul posts-

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Jatin Katyal Wed, 05/19/2010 - 18:53
User Badges:
  • Cisco Employee,

You can always take ACS backup from the GUI by going to System Configuration >>  Click ACS Backup >> enter the FTP information >> Backup now.


Performing a Manual ACS Backup

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.0/user/guide/sba.html#wp222516


Once you connected to ACS via CLI the default username and password if not changed would be
user= Administrator
Pass= setup



Establishing a Serial Console Connection

http://cisco.biz/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.0/installation/guide/appliance/instalap.html#wpxref17544


Backing Up ACS Data From the Serial Console

http://cisco.biz/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.0/installation/guide/appliance/admap.html#wp1057928


Regds,

JK


Do rate helpful posts-

cm6043 Wed, 05/19/2010 - 20:25
User Badges:

Hi jkatyal,


Thanks for your information. Could I get CLI prompt remotely ?


Thanks

Leung che Man

Correct Answer
Jatin Katyal Thu, 05/20/2010 - 02:50
User Badges:
  • Cisco Employee,

Unfortunately, that is not supported. You've to connect to ACS via hyperterminal using console cable.


Regds,

JK


Do rate helpul posts-

Actions

This Discussion