SRTP config example for voip trunks

Answered Question
Apr 4th, 2010

SRTP config example for voip  trunks

I have this problem too.
0 votes
Correct Answer by William Bell about 6 years 8 months ago

MGCP doesn't fit your requirements but you could use h323. You would need to configure ipSec to support the call signaling (if you want) and SRTP to support the media. Here is a Cisco write up on Media and Signaling encryption for IOS gateways:

https://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/htsecure.html

HTH.

Regards,

Bill

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
William Bell Sun, 04/04/2010 - 18:50

I think that the original poster is looking for information on SRTP not SRST.

kursatcoban Thu, 05/20/2010 - 07:02

Hi All ,

I found it , here is the sample config


voice-card 1
codec complexity high
local-bypass


conf t
voice service  voip
sip 
url sip
srtp negotiate cisco
exit
exit


conf t
dial-peer voice xxx voip
srtp
srtp system
security mode encrypted
exit

regards,

Kursat

xiangyong chu Tue, 12/21/2010 - 00:24

Hi,

can i ask some question about the SRTP protocol?

1. how can i configure the SRTP protocol for bandwidth guarantee in QOS rules;

2. what is the SRTP port used?

3. what is the ios for the SRTP command in dial-peer?

Marwan ALshawi Sun, 04/04/2010 - 18:31

if you use IPsec and you have any concern about QOS make sure to enable pre classify feature on the ipsec tunnel for QOS to make sure you keep the traffic marking and to avoid any qos issues

Actions

This Discussion

Related Content