Hi, I wanted to ask does CISCO1841 support 2 different dlsw remote-peer? The thing is we have the below configuration running fine on a CISCO2600 but not in 1841.
ip subnet-zero
!
isdn switch-type basic-net3
isdn voice-call-failure 0
!
dlsw local-peer peer-id <address>
dlsw remote-peer 0 tcp <address>
dlsw remote-peer 0 tcp <address>
dlsw bridge-group 1
!
!
!
!
interface Loopback0
description Loopback IP Address for site111 DLSW SNA
ip address <address> 255.255.255.252
no ip directed-broadcast
no ip route-cache
no ip mroute-cache
!
interface Ethernet0/0
description site111 LAN
ip address 10.51.64.1 255.255.255.0
no ip directed-broadcast
ip route-cache flow
bridge-group 1
!
interface BRI0/0
no ip address
no ip directed-broadcast
encapsulation ppp
dialer pool-member 1
isdn switch-type basic-net3
isdn tei-negotiation first-call
ppp authentication chap
!
interface Serial0/0
description site222 DQ : 13464870 (512kbps)
ip address <address> 255.255.255.252
no ip directed-broadcast
ip route-cache flow
no ip mroute-cache
!
interface Serial0/1
ip address <address> 255.255.255.252
no ip directed-broadcast
ip route-cache flow
shutdown
!
interface Dialer1
ip address <address> 255.255.255.252
no ip directed-broadcast
encapsulation ppp
dialer remote-name KJ-7206-01
dialer pool 1
dialer idle-timeout 300
dialer string ##########
dialer load-threshold 2 either
dialer-group 1
ppp authentication chap
ppp multilink
