Supervisor engine change out on Cat 4507

Unanswered Question
May 20th, 2010
User Badges:

Hi all,

I am about to do a supervisor engine IV change on a catalyst 4507. before I proceed in doing this, my intention was to practice doing the change out on a catalyst 4006.

Is it possible to do this and does anybody have any documentation on how to do this?


Regards,


Mark

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Thu, 05/20/2010 - 22:20
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

Hi all,

I am about to do a supervisor engine IV change on a catalyst 4507. before I proceed in doing this, my intention was to practice doing the change out on a catalyst 4006.

Is it possible to do this and does anybody have any documentation on how to do this?


Regards,


Mark


Hi Mark,


The Supervisor Engine IV is supported by the Catalyst 4006, 4503, 4506, and 4507R switches. Install the Supervisor Engine IV in slot 1 of all Catalyst 4000 family switches.


Check out the below link for step by step procedure for removing  module in 4000 series


http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/hardware/configuration/notes/78_14496.html


Hope to Help !!


Ganesh.H


Remember to rate the helpful post

Actions

This Discussion