Supervisor engine change out on Cat 4507

mjostler01 · ‎05-20-2010

Hi all,

I am about to do a supervisor engine IV change on a catalyst 4507. before I proceed in doing this, my intention was to practice doing the change out on a catalyst 4006.

Is it possible to do this and does anybody have any documentation on how to do this?

Regards,

Mark

Ganesh Hariharan · ‎05-20-2010

Hi all,

I am about to do a supervisor engine IV change on a catalyst 4507. before I proceed in doing this, my intention was to practice doing the change out on a catalyst 4006.

Is it possible to do this and does anybody have any documentation on how to do this?

Regards,

Mark

Hi Mark,

The Supervisor Engine IV is supported by the Catalyst 4006, 4503, 4506, and 4507R switches. Install the Supervisor Engine IV in slot 1 of all Catalyst 4000 family switches.

Check out the below link for step by step procedure for removing module in 4000 series

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/hardware/configuration/notes/78_14496.html

Hope to Help !!

Ganesh.H

Remember to rate the helpful post