7925G send / dial button

Unanswered Question
May 21st, 2010

Hi,

This is a really simple question but I cannot seem to find a solution:

On a 7925G, when I dial a number using digits and then push "Send" (Green) button, nothing happens. Also if I choose "Dial" from Actions, nothing happens. On another hand, if I push "Send" button first, I hear dialtone and can dial.

This is a UC500 with CME 8, Phone FW is 1.3.3

The nearest I came to defining send key "action" was a

service phone sendKeyAction

command, but the described behaviour does not change, does not matter if it is set to 0 or 1.

Any ideas how to fix this?

Thanks!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ryanbevan Fri, 07/05/2013 - 01:11

Hi,

I had the same problem and i resolved it by recreating the cnf-files under the telephone-serivce .

#conf t

(config)#telephony-service

(config-telephony)#create cnf-files

Hope this works for you .

Thanks,

Ryan

Actions

This Discussion