I've read through config guides
for Nexus 5000 & 2000, but neither one tells me if the ports on
Nexus 2K's support trunk, or how to configure those ports.
On the 5K side, it says to configure them as the fex port, but how do I drop into the individual 2K ports to configure them?
Is there a command such as "interface x/y/z" for these fabric extenders?

Hi,

Check out the below link for trunk port configuration in nexus switches

http://www.ciscointernethome.org/en/US/docs/switches/datacenter/nexus5000/sw/layer2/Cisco_Nexus_5000_Series_NX-OS__chapter6.html#task_1276775

Hope to help !!

Ganesh.H

Remember to rate the helpful post