05-25-2010 05:28 AM - edited 03-15-2019 10:55 PM
if i am using VWIC2-2MFT-T1/E1 cards still we need WIC-2t card for serial connectivity or else VWIC2-2MFT-T1/E1 support both data & Voice in CISCO2851-CCME/K9.
05-25-2010 05:37 AM
If I understand the question correctly, the answer is that the VWIC2-2MFT-T1/E1 is a voice only card. Therefore, you would need the wic-2t or similar card for WAN/carrier connectivity.
HTH.
Regards,
Bill
Please remember to rate helpful posts using the scale below.
Please remember to rate helpful responses and identify
05-25-2010 07:29 AM
Mohammad,
My apologies. A colleague informed me that I was a dumb *** ;-) I neglected to pay close enough attention to the question. Actually, you can mix voice and data applications. Depends on what is on the other end. Here is a Q&A link:
http://www.cisco.com/en/US/prod/collateral/routers/ps5855/prod_qas0900aecd8028d2e5.html
HTH.
Regards,
Bill
Please remember to rate helpful responses and identify
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: