Upgrade 2620XM

Answered Question
May 25th, 2010

i have 2620XM with 48F and 256D only no any more

i want to run E1 by module VWIC2-1MFT-G703

if i buy PVDM-12 ?   is it enough to run it , am i need any additional module to run PVDM-12 , how many chanel PVDM-12 give me?

ibrahim

best regards

I have this problem too.
0 votes
Correct Answer by Walter Solano about 6 years 6 months ago

You will require a NM to hold the PVDMs

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Walter Solano Tue, 05/25/2010 - 08:14

Hello  Ibrahim

The best way to calculate the amounth of PVDMs that you need to acomplish certain tast is using the DSP calculator.

http://www.cisco.com/pcgi-bin/Support/DSP/cisco_prodsel.pl

Also this documents will give you better information about PVDMs

http://www.cisco.com/en/US/prod/collateral/routers/ps5854/product_data_sheet0900aecd8016e845.html

http://www.cisco.com/en/US/tech/tk652/tk698/technologies_tech_note09186a0080a7af82.shtml

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Ibrahim Mohamed... Tue, 05/25/2010 - 08:31

thank you ,

but i need to know if i must have NM-HDV module or i can applay PVDM -12 on  board ,  are there slot in board to applay PVDM or must have NM-HDV?

ibrahim

Correct Answer
Walter Solano Tue, 05/25/2010 - 08:44

You will require a NM to hold the PVDMs

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Ibrahim Mohamed... Wed, 05/26/2010 - 00:38

Can i hold PVDM-12 in AIM slot ?

Are 2800 also recuired module to hold PVDM2-8 or it has 2 PVDM2 slot ?

thanks

ibrahim

Actions

This Discussion