Solved: Upgrade 2620XM

Ibrahim Mohamed El.Hady El.Sheref · ‎05-25-2010

i have 2620XM with 48F and 256D only no any more

i want to run E1 by module VWIC2-1MFT-G703

if i buy PVDM-12 ? is it enough to run it , am i need any additional module to run PVDM-12 , how many chanel PVDM-12 give me?

ibrahim

best regards

Walter Solano · ‎05-25-2010

You will require a NM to hold the PVDMs

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Walter Solano · ‎05-25-2010

Hello Ibrahim

The best way to calculate the amounth of PVDMs that you need to acomplish certain tast is using the DSP calculator.

Also this documents will give you better information about PVDMs

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Ibrahim Mohamed El.Hady El.Sheref · ‎05-25-2010

thank you ,

but i need to know if i must have NM-HDV module or i can applay PVDM -12 on board , are there slot in board to applay PVDM or must have NM-HDV?

ibrahim

Walter Solano · ‎05-25-2010

You will require a NM to hold the PVDMs

HTH

Please rate this post if was helpful

Walter Solano

CCNA Voice

Cisco UCCX Specialist

Ibrahim Mohamed El.Hady El.Sheref · ‎05-26-2010

Can i hold PVDM-12 in AIM slot ?

Are 2800 also recuired module to hold PVDM2-8 or it has 2 PVDM2 slot ?

thanks

ibrahim