how i can see memory amount of AP lightweight

Answered Question
May 25th, 2010

Hello,

in the network, i have a WLC 2112 and two access point lightweight, i need know how much flash an nvram have the access points?

you know what command i set in the WLC for know how much flash an ram have the access point and the Wireless Lan Controller??

thanks

I have this problem too.
0 votes
Correct Answer by Leo Laohoo about 6 years 6 months ago

You have two options:  You can run debug command and/or enable Telnet/SSH.

To enable debug command on the WLC, run the following commands:

1.  debug ap enable ;
2.  debug ap command "dir" ; (you can also use "sh flash:")

When you are finish or satisfied with the result, disable the debug command.

3.  debug ap disable

To enable Telnet/SSH

Depending on the version of your WLC you do this via GUI or CLI.  The CLI command on the WLC is:  config ap [telnet/ssh] enable

Please don't forget to rate useful posts.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Leo Laohoo Tue, 05/25/2010 - 15:29

You have two options:  You can run debug command and/or enable Telnet/SSH.

To enable debug command on the WLC, run the following commands:

1.  debug ap enable ;
2.  debug ap command "dir" ; (you can also use "sh flash:")

When you are finish or satisfied with the result, disable the debug command.

3.  debug ap disable

To enable Telnet/SSH

Depending on the version of your WLC you do this via GUI or CLI.  The CLI command on the WLC is:  config ap [telnet/ssh] enable

Please don't forget to rate useful posts.

Actions

This Discussion