Device configs are stale

Unanswered Question
May 25th, 2010
User Badges:

How do I configure LMS 3.2 to periodically update it's knowledge of the device configuration?


Last week, I setup a poller to tell me whenever a router interface goes down.  HUM started reporting threshold violations on a few gre tunnels that were left over out on my network.  I went our to the router and remove the gre tunnel interfaces.  Yet, still HUM is reporting that those tunnels are down.


Is there a job that should be running periodically that will tell HUM that those interfaces no longer exist on the nextwork?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Sat, 05/29/2010 - 22:40
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

A thread should be running out of UPMProcess which detects ifIndex and ifAdminStatus state changes.  The logs are IfAdminStatus.log and UPMChangeDetection.log.  Check to see if you're seeing any errors in those logs.

Tod Larson Tue, 06/01/2010 - 16:54
User Badges:

Sir,

Where do I find  IfAdminStatus.log and UPMChangeDetection.log?

Thank you,

TOd

Joe Clarke Tue, 06/01/2010 - 18:05
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

On Windows under NMSROOT\log and on Solaris under /var/adm/CSCOpx/log.

Actions

This Discussion

Related Content