Unity Connection Clustering across WAN

Answered Question

Hi all,


I am looking into deploying a Unity Connection cluster with the Publisher in Ca and the Subscriber in Tx. The Ca location and the Tx location are connected over a full 45MB DS3 connection and the round-trip latency is about under 40ms. There will be 48 voice mail ports total on each server.


I am trying to find out the minimum bandwidth requirement for replication and intra-cluster communication traffic between the Pub and Sub.


Has anyone deploy anything like this for Unity Connection ? Is this a supported deployment ? I appreciate any inputs / suggestions !!!! Thanks in advance !!!


D.

Correct Answer by William Bell about 6 years 12 months ago

When Unity Connectio

n cluster servers are deployed in separate buildings, the following requirements/best practices apply:


  • Bandwidth
    • 50 Mbps for 48 voice messaging ports on each server
    • 100 Mbps for 86 voice messaging ports on each server
    • 150 Mbps for 144 voice messaging ports on each server
  • Latency of 20ms or less RTT


Available here:  http://www.cisco.com/en/US/docs/voice_ip_comm/connection/7x/requirements/7xcucsysreqs.html#wp151620



HTH.


Regards,

Bill

Please remember to rate helpful posts.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (4 ratings)
Loading.
Correct Answer
William Bell Tue, 05/25/2010 - 21:55
User Badges:
  • Purple, 4500 points or more

When Unity Connectio

n cluster servers are deployed in separate buildings, the following requirements/best practices apply:


  • Bandwidth
    • 50 Mbps for 48 voice messaging ports on each server
    • 100 Mbps for 86 voice messaging ports on each server
    • 150 Mbps for 144 voice messaging ports on each server
  • Latency of 20ms or less RTT


Available here:  http://www.cisco.com/en/US/docs/voice_ip_comm/connection/7x/requirements/7xcucsysreqs.html#wp151620



HTH.


Regards,

Bill

Please remember to rate helpful posts.

Actions

This Discussion