Solved: SSH connection to 2600XM from Poderosa

okumura · ‎05-25-2010

Hi,

Today, I have established SSH connection to 2600XM from Poderosa.

But I can not shift to "enable mode" such as following...

****************************************************************************************

R01>enable

Password: c

(When I input first letter of password "cisco", ssh-session disconnect suddenly.)

(R01 accepts another command , for example...)

R01>show version

Cisco IOS Software, C2600 Software (C2600-ADVENTERPRISEK9-M), Version 12.3(11)T7, RELEASE SOFTWARE (fc3)

****************************************************************************************

I can shift to "enable mode" by serial connection.

(COM1:9600baud)*******************************************************************

R01>enable
Password: cisco

R01#
****************************************************************************************

Additionary, I can establish SSH connection to C2950-24 and shift to enable mode from Poderosa.

(SSH from Poderosa)****************************************************************

SW03>enable
Password: cisco
SW03#show version
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6K2L2Q4-M), Version 12.1(22)EA13, RELEASE SOFTWARE (fc2)

****************************************************************************************

Sorry, I'm not good at English.

Could you help me?

Regards,

Giuseppe Larosa · ‎05-26-2010

Hello Okumura,

try to use another software like putty that is freeware

you can find it here:

http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html

sometimes an SSH client can crash for an SSH version mismatch

likely the switch is using SSHv1, the router may be using a later version

Hope to help

Giuseppe

View solution in original post

Giuseppe Larosa · ‎05-27-2010

Hello Okumura,

I simply had the same problem before you

I'm happy you solved

Hope to help

Giuseppe

View solution in original post

Giuseppe Larosa · ‎05-26-2010

Hello Okumura,

try to use another software like putty that is freeware

you can find it here:

http://www.chiark.greenend.org.uk/~sgtatham/putty/download.html

sometimes an SSH client can crash for an SSH version mismatch

likely the switch is using SSHv1, the router may be using a later version

Hope to help

Giuseppe

okumura · ‎05-26-2010

Hello Mr.guislar.

Thank you for your reply.

I succeeded by putty!

> sometimes an SSH client can crash for an SSH version mismatch

> likely the switch is using SSHv1, the router may be using a later version

-> This is valuable information for me. Thank you.

Regards,

Giuseppe Larosa · ‎05-27-2010

Hello Okumura,

I simply had the same problem before you

I'm happy you solved

Hope to help

Giuseppe

okumura · ‎06-04-2010

Sorry, I didn't know the rule of this community.

I just clicked some stars.

Regards,