Unified Communications Network Management Licensing

Unanswered Question
May 26th, 2010


i have purchased all 4 VOIP Network Management Software (CUOM, CUSM, ecc...) with their PAK. Now i'm going to register the 4 PAK, but i have a doubt: Cisco requires the MAC address of the server that hosts the Management Software. I have installed the Cisco software on 2 HP dl380 servers with 4 NIC's and, on each server, i configured 2 NIC's in load balance (with embedded HP network software): the other 2 NIC's are disconnected.

Is there someone that can tell me which MAC address i must provide to Cisco PAK registration ?

Thank you,


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion