Integrating Cisco CallManager 7.0 and CME using sip trunk

Unanswered Question
May 26th, 2010


I just installed CUCM 7.1.3 in my test lab and also have got CCME 7 on cisco 2811(IOS version 12.4(24(T)).

On CUCM 7 I have got range of number 6000-7000

registered phone 6000

ON CCME I have got 2000-3000

registered phone 2000

normaly in order to call to another ccme from ccme I used:

dial-peer voice 101 voip
description ##  ##
destination-pattern 5...
codec g711alaw
session protocol sipv2
session target ipv4:
dtmf-relay rtp-nte

but If I do the same with the CUCM I am getting a message unknown number(after calling 6000).

I also set up set trunk from CUCM to ccme and added route pattern for extention 2000 it should go to ccme,

but when I am getting bussy signal.

I have been checking this link __ and dont think it should be much different from above.

Can you help me with setting it up and get it working please?

Many thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Vasily_Kr Fri, 05/28/2010 - 04:34

Problem was resolved.

I did use wrong session target ip address.


This Discussion