Hi all,
Iam having a 7606 router and it is directly connected by two swithces
and one PC.One of the switch1 is the source of the multicast and
destinations are are either in switch2 or PC.
Iam having very limited concept strength in Multicast.(Not much time to read and build the same)
Please lemme know which mode i need to take?(sparse/dense)
Which are the configuration steps to achieve the same?
steps of concepts ?
Any help would be very much appreciable.
Thanks in advance.
Mahesh
Hi Mahesh,
Check out the below links for step by step configuration of IP Multicast configuration
http://www.cisco.com/en/US/tech/tk828/technologies_tech_note09186a0080094821.shtml
Hope to Help !!
Ganesh.H
Remember to rate the helpful post