PPPoE Cisco 877

Answered Question
May 27th, 2010
User Badges:

Hello,


I have a WAN line with 3Com Router and I want to change this router for one Cisco 877. The parameters of line are these:


VPI/VCI  8/48

Encapsulation LLC

Protocol PPPoE

Authentication : chap or pap (i don't know) User and password are plain text.

NAT: Disable. NAT is done by Firewall.

WAN IP: automatic

LAN IP: IP public static.


I've already configured router but I don't know if the configuration is all right. I attach it.


It's ok?


Best Regards,

Attachment: 
Correct Answer by spremkumar about 7 years 2 months ago

Authentication,Routing looks ok.


you try connecting the same and let us know here.


Also if you have some production (working) traffic on the circuit you can try out doing this test after off peak/production hours.


regds

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
spremkumar Thu, 05/27/2010 - 03:26
User Badges:
  • Red, 2250 points or more

Hi Javi


do u have any specific reason to configuring the specific mtu size under the dialer0 interface ?


I have seen the below config as the working configs in few locations.



int vlan1

ip tcp adjust-mss 1452

ip virtual-reassembly


int di0

ip tcp adjust-mss 1452

ip mtu 1492

ip virtual-reassembly


if you need to have the specific mtu size and mss would suggest not to change, else pls try with the above config and check.


regds

Javi Benito Thu, 05/27/2010 - 03:46
User Badges:

Ok I´ll change it.


The rest of the config it's ok (authentication, acl, routing, etc)?

Correct Answer
spremkumar Thu, 05/27/2010 - 03:51
User Badges:
  • Red, 2250 points or more

Authentication,Routing looks ok.


you try connecting the same and let us know here.


Also if you have some production (working) traffic on the circuit you can try out doing this test after off peak/production hours.


regds

Javi Benito Tue, 06/01/2010 - 01:29
User Badges:

Hi,


I've changed 3com router by cisco 877 and doens't work. Led "CD" of Router cisco is blinking. What is the meaning? is not compatible with type of the line?


regards,


javi

Javi Benito Tue, 06/01/2010 - 08:05
User Badges:

Hi newly,


ISP confirm me that cisco 876 router is not compatible then CD is blinking. ISP's told me that the correct router is cisco 876 because is a ADSL 2+ „ANNEX B“.


I would like to know if the configuration that I have in my 877 is the same with 876 router or I have to change some parameters.


Best Regards,


Javi

Actions

This Discussion