cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
18029
Views
5
Helpful
4
Replies

Configure SNMP in CUCM for Monitoring

dtran
Level 6
Level 6

Hi all,

Does anyboby have information on configuring SNMP in CUCM for monitoring ? or the MIB information for CUCM 7.1 ?

Thanks in advance !!

D.

1 Accepted Solution

Accepted Solutions

Jonathan Schulenberg
Hall of Fame
Hall of Fame
4 Replies 4

Jonathan Schulenberg
Hall of Fame
Hall of Fame

There is a chapter about this in the Servicibility Guide, including a checklist:

Understanding Simple Network  Management Protocol

Cisco Unified Serviceability  Administration Guide, Release 8.0(2)

Hi Jonathan,

Thanks for responding to my post !! very much appreciate it.

Do you know if Cisco provide MIB information on CUCM services ? I am looking for the MIB OID number for each of CUCM service. My monitoring system requires the OID number to query the services.

Thanks again !!!

D.

Yes. A wealth of information on MIBs available with CUCM are provided in the CUCM Managed Services Guide:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/managed_services/ManagedServices.html

In particular, the following section should directly answer your question:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/managed_services/industry_mibs.html#wp1145376

You will want to review the sections on feature and network services.  I know the section headers reference CUCM 6x and they are in a CUCM 7x book, but the OIDs should still apply to 7x.

HTH.

Regards,
Bill

Please remember to rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Page not Found !

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: