05-28-2010 05:55 AM
Hi,
I am doing some fairly basic loadbalancing with sticky connections based on source IP. If I do a show Serverfarm XXX command I can see 80 connections going to one server and 890 going to another.
Now if I do a show conn rserver XXX-1 serverfarm XXX | count
show conn rserver XXX-2 serverfarm XXX | count
I can see 165 connections going to the first server and only 9 going to the second.
This sounds about right for the first server considering the in and out connections. But the second server has me confused with the number showing. I have tried the clear conn for that rserver but the figure seems to hover around 890 - 900. Load balancing is Round Robin at the moment.
The second server is functioning ok as I can access it when bypassing the loadbalancer.
We have rebooted the second server and even when the probe-failed status was showing for the server, the current connections from the Show Serverfarm XXX command still showed around the 890 mark.
Has anybody seen this before and know of a way to reset this counter?
Cheers
Brian
Solved! Go to Solution.
06-01-2010 12:51 AM
we had several issues in the past with the count of active connections in 'show serverfarm'.
Could you test the latest version and if the problem persists open a service request with the TAC to report the problem so we can fix it.
Thanks.
Gilles
06-01-2010 12:51 AM
we had several issues in the past with the count of active connections in 'show serverfarm'.
Could you test the latest version and if the problem persists open a service request with the TAC to report the problem so we can fix it.
Thanks.
Gilles
06-01-2010 04:03 AM
Thanks Giles, it is good to know I wasn't going crazy looking at those figures. Will plan the upgrade.
Cheers
Brian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide