QoS for Internet Link (DSL)

Unanswered Question
May 30th, 2010
User Badges:

Dears;

we have an internet link 2 Mbps and i want to do a QoS for the email traffic, so i want to reserve 1 Mbps from the incoming and outgoing emails. please advice with the configuration lines. the email servers are 172.16.20.20 and 172.16.20.21 the current configuration of the router as the following:


!
vpdn enable
!
vpdn-group 1
request-dialin
  protocol pppoe
!
!
!
!
!
archive
log config
  hidekeys
!
!
!
!
!
interface FastEthernet0/0
description Connected to LAN
ip address 172.16.20.1 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
description connected to the modem (ISP)
bandwidth 2048
no ip address
duplex auto
speed auto
pppoe enable group global
pppoe-client dial-pool-number 1


!
interface Dialer1
bandwidth 2048
ip address negotiated
ip mtu 1492
ip nat outside
ip virtual-reassembly
encapsulation ppp
no ip mroute-cache
dialer pool 1
dialer-group 1
no cdp enable
ppp authentication pap callin
ppp chap refuse
ppp ms-chap refuse
ppp pap sent-username [email protected] password 7 101F5B4A5142
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 Dialer1
no ip http server
no ip http secure-server
!
!
ip nat inside source list 1 interface Dialer1 overload



//natting for the email servers
ip nat inside source static 172.16.20.20 83.101.100.101

ip nat inside source static 172.16.20.21 83.101.100.102


!
!
access-list 1 permit any
dialer-list 1 protocol ip permit
!
!


Message was edited by: kayocisco

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
Ganesh Hariharan Sun, 05/30/2010 - 22:34
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

Dears;

we have an internet link 2 Mbps and i want to do a QoS for the email traffic, so i want to reserve 1 Mbps from the incoming and outgoing emails. please advice with the configuration lines. the email servers are 172.16.20.20 and 172.16.20.21 the current configuration of the router as the following:


!
vpdn enable
!
vpdn-group 1
request-dialin
  protocol pppoe
!
!
!
!
!
archive
log config
  hidekeys
!
!
!
!
!
interface FastEthernet0/0
description Connected to LAN
ip address 172.16.20.1 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
description connected to the modem (ISP)
bandwidth 2048
no ip address
duplex auto
speed auto
pppoe enable group global
pppoe-client dial-pool-number 1

Hi,


For your information QoS doesn't interact unless there is congestion on the link,First Define the classes (for mail use the protocols like pop3 or smtp)


class-map match-any mail
match protocol pop3
match protocol smtp
match protocol imap
match protocol secure-pop3
match protocol secure-imap
match protocol exchange
match protocol ldap


Assign each traffic class the appropriate bw:
policy-map qos
class mail
bandwidth percent 50
class class-default
fair-queue


Apply the policy under each interface in the output direction:
interface serial 0/0
bandwidth 2048
service-policy output qos



Hope to Help !!


Ganesh.H


Remember to rate the helpful post

kayocisco Tue, 06/01/2010 - 07:40
User Badges:

Dears;

this is about outgoing emails, what about the incoming email? can i do QoS for incoming emails too?


Thanks;


Kayo

Actions

This Discussion