05-31-2010 09:22 AM - edited 03-15-2019 11:01 PM
hello everyone
How to set up a few branches when connecting to other internal extensions do not appear on the screen of the number receiving the call?
Can I put limited number or another number for anyone to call back
any help will be appreciated
Solved! Go to Solution.
06-10-2010 08:51 AM
Then your configuration is wrong at some place, the procedure outlined does work
Original DN cannot reach destination DN via CSS
Original DN reaches TP which blocks ANI.
TP CSS reaches destination TP.
Most likely your error is in CSS and partitions, review your configuration.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
05-31-2010 09:31 AM
I'll assume this is CUCM so read this:
05-31-2010 09:53 AM
I read and any questions I post
Thanks
06-10-2010 08:39 AM
I followed the procedures but did not work
I created the CSS and the Partition restricted. Configured not to display the extension number on the screen.
This partition must access all branches but the other branches belonging to domestic participants can not call these extensions.
06-10-2010 08:51 AM
Then your configuration is wrong at some place, the procedure outlined does work
Original DN cannot reach destination DN via CSS
Original DN reaches TP which blocks ANI.
TP CSS reaches destination TP.
Most likely your error is in CSS and partitions, review your configuration.
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide