Recently we acquired several Verizon network extenders to help boost cell phone reception in areas where it is exceptionally poor. These things should simply work by plugging them in. However that is not the case. What i've discovered is that the devices don't seem to work on 10.x networks at all. What i've got to do is add another vlan on a completely separate ip block to my network and have it routed outside properly.
Since I'm typically used to dealing with IOS based devices and only basic commands and interactions this seemed like a daunting task to me. I managed to figure out which switch and port I wanted to configure for this new internal vlan ( i called it VLAN 192) And i'm pretty sure I properly configured it on the individual switch. Additionally I've got the scope perperly setup in DHCP. However I havn't got the foggiest on what to do with my 6509 to get this to work. It seems to be running CatOS so i'm already slightly lost, but then from what I've gathered i've got to add the vlan to the management side of it, something i've never touched.
Can anyone give me a basic overview of the steps I should be taking and commands I'm going to need to get this vlan working throughout my network.