cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
438
Views
0
Helpful
1
Replies

TwinGig Convertors

henry.saravia
Level 1
Level 1

there is some limitation to configure EtherChannel on cards WS-X4606-X2-E and WS-X4306-GB using TwinGig converters?

1 Reply 1

Ganesh Hariharan
VIP Alumni
VIP Alumni
there is some limitation to configure EtherChannel on cards WS-X4606-X2-E and WS-X4306-GB using TwinGig converters?

Limitation of using twingig converter is in a Supervisor Engine 6-E system, the ports are connected to the switching engine through a stub ASIC. This stub ASIC imposes some limitations on the ports: Gig and 10 Gig ports cannot be mixed on a single stub ASIC; they must either be all 10 Gig (X2), or all Gig (TwinGig Converter and SFP).

Check out the below link

http://conft.com/en/US/docs/switches/lan/catalyst4500/12.2/50sg/configuration/guide/sw_int.html

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco