Ethernet CFM on 7600 ES+ ports

Unanswered Question
Jun 2nd, 2010
User Badges:

I'd like to be able to configure an inward (UP) facing MEP on the ES+ interface as I have directly attached (unmanaged) CPE.


Is this possible in 12.2(33)SRE1?


When i try and apply a MEP to the physical interface or service instance I see the following message.



router(config-if)# ethernet cfm mep domain CUSTOMER mpid 1 vlan 7

Up direction MEP is not supported on Gi7/19. Command Aborted.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Mon, 06/14/2010 - 04:18
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

I'd like to be able to configure an inward (UP) facing MEP on the ES+ interface as I have directly attached (unmanaged) CPE.


Is this possible in 12.2(33)SRE1?


When i try and apply a MEP to the physical interface or service instance I see the following message.


router(config-if)# ethernet cfm mep domain CUSTOMER mpid 1 vlan 7

Up direction MEP is not supported on Gi7/19. Command Aborted.

Hi,


Check out the usage guideline for MEP in cisco 7600 routers,


http://www.cisco.com/en/US/docs/routers/7600/install_config/ES40_config_guide/es40_chap4.html


Hope to Help !!


Ganesh.H


Remember to rate the helpful post

Actions

This Discussion

Related Content