cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1119
Views
0
Helpful
2
Replies

frame-relay

hblfzhangzhiwei
Level 1
Level 1

R1-----R5-----R3,R5 is frame-relay switch ,. R1 can not communite with R3, what is the wrong ,please ?

R5

interface Serial1/0    ###### to R1
no ip address
encapsulation frame-relay
serial restart-delay 0
frame-relay lmi-type cisco
frame-relay intf-type dce
frame-relay route 231 interface Serial1/1 233
!
interface Serial1/1     #### to R3
no ip address
encapsulation frame-relay
serial restart-delay 0
frame-relay lmi-type cisco
frame-relay intf-type dce
frame-relay route 233 interface Serial1/0 231

R1

interface Serial1/0
ip address 1.1.1.1 255.255.255.0
encapsulation frame-relay
serial restart-delay 0

R3

interface Serial1/1
ip address 1.1.1.2 255.255.255.0
encapsulation frame-relay
serial restart-delay 0

1 Accepted Solution

Accepted Solutions

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Zhiwei,

on DTE routers try to use point-to-point subinterfaces and to use frame-relay interface-dlci to see if the issue is related to inverse-ARP

Hope to help

Giuseppe

View solution in original post

2 Replies 2

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Zhiwei,

on DTE routers try to use point-to-point subinterfaces and to use frame-relay interface-dlci to see if the issue is related to inverse-ARP

Hope to help

Giuseppe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco