cme imap integration

Unanswered Question
Jun 4th, 2010

Hi folks,

Im looking for a config exemple of how setup the cue 3.1 to support imap.

tks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
William Bell Sat, 06/05/2010 - 07:49

I believe the answer to your question is laid out in the following configuration guide:

http://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/rel3_2/administrator/voicemail/12advVM.html#wpmkr1025284

Configuring Integrated Messaging

Follow this procedure to configure the Integrated Messaging capability.

Prerequisites

The system must have a default security certificate and private key  installed before SSL connections are permitted on Cisco Unity Express.  Use the show crypto key command to display  the system default certificate-key pair. If no default pair exists,  follow the procedure in "Configuring Security"  on page 295.

Required Data for This Procedure

Name of a subscriber group that has the vm-imap privilege.

SUMMARY STEPS

1. config t

2. service imap

3. enable

4. maxsessions num-sessions

5. session idletimeout minutes

6. session security {ssl | none | mixed | keyLabel labelname}

7. enable

8. no enable


HTH.

Regards,

Bill

Please remember to rate helpful posts.

plafrance Sun, 06/06/2010 - 15:51

Hello William,

tks for the answer,

im looking for a sh run sample config. Also if you have a screen shoot in outlook how to setup the mail accompt.

tks all

Actions

This Discussion