06-05-2010 12:26 AM - edited 03-04-2019 08:41 AM
Hi all,
I have Cisco 3750-24PS-S switch, which IOS mistakenly erase, I have run switch:format flash: command also,
I tried Xmodem recovery for upload IOS on flash, but it gives I/O error while uploading the IOS,
So plz give the complete procedure for IOS recovery through HyperTerminal OR any another method/
also attached is a snapshot of that error,
Regards,
Vaibhav S.
06-05-2010 04:34 PM
Kindly enter the following commands first:
init_switch
load_helper
06-07-2010 08:06 AM
Please try the following steps to disaster recovery.
Do check the connections before proceeding:
flash_init
load_helper
dir flash:
set baud 115200 --> for faster transfer please change the baud rate
copy xmodem:flash:
More details provided in the following link:
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
More details of the error message can be found in error decoder in cisco.com site:
Hope it helps!
Regards,
podhillo
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: