cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3074
Views
0
Helpful
3
Replies

Setting uplink port on Catalyst 2900 series Switch

Chris_M_Miller
Level 1
Level 1

Greetings, I'm working on my CCNA and I want to copy down the IOS to my Linux box via TFTP before making any major configuration changes (basically back it up).

I've noticed I don't have an uplink port on the Switch and not really sure how to go about this.

Also can I use CAT5 or will I have to use Cross-Over?

thanks

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

Also can I use CAT5 or will I have to use Cross-Over?

As long as the speed and duplex are set to auto then MDI/MDI-X is enabled.

I've noticed I don't have an uplink port on the Switch and not really sure how to go about this.

Connect your host to the switch, give the switch an IP address and enable TFTP and you should be able to copy the IOS from the switch to the client.

[quote]

As long as the speed and duplex are set to auto then MDI/MDI-X is enabled.

[/quote]

I'm not sure how to confirm if MDI/MDI-X is enabled or not on the Switch.

Forgot to include this other detail.  All of the devices (Linux pc and Cisco Switch) are connected to a Linksys SOHO Router/Switch.  Will this make a difference?  I wouldn't think so as long both devices can ping each other.

thanks

In the interface configuration, enter the command "mdix auto".

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: