Catalyst Express 520 series running the factory default image

Unanswered Question

What´s up!!

I have a problem with my catalyst 520 series switch, The alert led is ambar all the time, reviewing the alert log, the problem is that the switch is running from the default factory image, When I clear the error the  alert led turns off, but at next refresh the error appears again.

Would somebody help me with this problem??

Thanks!!!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jochem Sparla Tue, 07/20/2010 - 06:51

We have the same problem on several switches.

You can clear the alert LED, but it just comes back in 30 seconds or so.

All switches are the latest firmware (12.2.37 EX), so flashing the firmware can't be the solution.

Hard/soft reset did not work. Does anyone have a solution?

Actions

This Discussion