ā06-07-2010 09:12 PM - edited ā03-06-2019 11:27 AM
Hi,
I am planning to start using port teaming on a HP DL360 G6 server that is connected to a Cisco Catalyst model 2960. Are there any special configuration that I need to make on the Cisco Catalyst in order for the port teaming on the HP server to work?
Regads,
Solved! Go to Solution.
ā06-07-2010 10:39 PM
That depends upon what kind of teaming you gonna use..
1. Fault tolerance >> No configuration required on switch side, use the same port type access/trunk
2. Transmit Load Balance with FT >> no configuration required on switch side, use the same port type access/trunk
3. Switch assisted FT >> Etherchannel using LACP for bundled ports on switch.
For further reading please go through below link for teaming
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01415139/c01415139.pdf
Hope this helps
Hitesh Vinzoda
Pls rate useful posts
ā06-07-2010 10:00 PM
EtherChannel.
ā06-07-2010 10:39 PM
That depends upon what kind of teaming you gonna use..
1. Fault tolerance >> No configuration required on switch side, use the same port type access/trunk
2. Transmit Load Balance with FT >> no configuration required on switch side, use the same port type access/trunk
3. Switch assisted FT >> Etherchannel using LACP for bundled ports on switch.
For further reading please go through below link for teaming
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c01415139/c01415139.pdf
Hope this helps
Hitesh Vinzoda
Pls rate useful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: