Cisco 10K read-only config interface

Unanswered Question
Jun 9th, 2010

Dear Cisco diehards

I have a question, and can't find the answer of it. To make a long story short....

The company i work is using a Cisco 10K for configuring xDSL lines. I would like to know if it is possible to make a specific interface configuration read-only. I dont have much Cisco experience, but hope i explained it correctly.

Someone has a solution for it?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion

Related Content