Solved: Could set disable/enable learning

ken.vance · ‎06-09-2010

Dear All,

When saving my config using 'wr mem' I get four lines of text:

Could set disable/enable learning

And the config saves without issue.

Does anyone know what this means?

Regards,

Ken Vance

ehoffman · ‎07-28-2014

I know this old but I ran into this today and have an answer for you. You were probably using an 4 port hwic card in an EHWIC slot. Hope this helps someone else down the road.

View solution in original post

Giuseppe Larosa · ‎06-09-2010

Hello Ken,

in order to get better help provide:

an example of the output

router model and IOS image name (sh ver)

Hope to help

Giuseppe

ken.vance · ‎06-10-2010

Hi, thanks for your response:

RC06#show ver
Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.4(10c), RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Mon 23-Jul-07 22:43 by prod_rel_team

ROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)

RC06 uptime is 1 year, 44 weeks, 5 days, 23 hours, 18 minutes
System returned to ROM by power-on
System restarted at 13:19:53 BST Thu Jul 31 2008
System image file is "flash:c2800nm-spservicesk9-mz.124-10c.bin"

And again:

RC06#wr mem
Building configuration...

Could set disable/enable learning

Could set disable/enable learning
[OK]

ehoffman · ‎07-28-2014

I know this old but I ran into this today and have an answer for you. You were probably using an 4 port hwic card in an EHWIC slot. Hope this helps someone else down the road.