06-09-2010 12:27 PM - edited 03-11-2019 10:57 AM
Hi All,
I've been trying to figure the syntax for a "packet-tracer" like command for FWSM 2.3. Does the IOS support this command?
If not, does anyone know an alternative to test ACL/NAT rules in FWSM 2.3 without actually sending a real traffic thru it?
Thanks in Advance.
Solved! Go to Solution.
06-10-2010 04:17 PM
Packet Tracer is not available to FWSM codes at the moment.
There is no simulation type commands that you can use with the FWSM code at the moment. You wqill have to test with real traffic, and check logs or do packet captures, to check for results.
Regards,
06-10-2010 04:17 PM
Packet Tracer is not available to FWSM codes at the moment.
There is no simulation type commands that you can use with the FWSM code at the moment. You wqill have to test with real traffic, and check logs or do packet captures, to check for results.
Regards,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: