06-11-2010 01:57 AM - edited 03-06-2019 11:32 AM
Hi,
I try to enter the command "ip policy route-map" on 3750's interface. But the command doesn't appear.
Why? Whereas I see several times that this command is possible on this switch.
What I have to do to enter this command?
Thanks!
06-11-2010 02:12 AM
Sebastien
To run PBR on the 3750 you need -
1) to be using the IP services image and not the IP Base image
2) you need to run the routing sdm template ie.
3750# sh sdm prefer
will show you the current template
3750(config)# sdm prefer routing
will enable the routing template.
Note that a change in the sdm template requires a reload of the switch.
Jon
06-11-2010 02:29 AM
How to activate the "Ip services image" instead of "Ip base image"?
Because I just have activated PBM like you wrote it and the command "ip policy route-map" still doesn't appear.
I use the IOS 12.2(35) version.
06-12-2012 05:31 AM
Excellent! It worked this way for me. Thanks a lot.
10-06-2013 01:39 AM
Hi John,
I have the same problem Sebastian has, and I have a cisco catalyst WS-C3750G-24PS stack with four switches.
I'm using C3750 Software (C3750-IPSERVICESK9-M), Version 12.2(55)SE8.
I also inserted the command you described about to prever SDM routing profile exactely as you described but I'm still unable to insert the command ip policy router-map statement on the virtual inteface.
What I'm doing wrong ?
Thank's a lot for yoour further suggestions
Fabio
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: