Hi Nagesh, I have look this for you, I quoted from link bellow. try that see if resolves the issue. or try installing the version 2.3 which was fixed . http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a00809b4754.shtml#rty
http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a00809b4754.shtml#erm
This issue is due to Cisco bug ID CSCsm54689 . In order to resolve this issue, make sure that Routing and Remote Access Service is disabled before you start AnyConnect. If this does not resolve the issue, complete these steps:
Open a command prompt as an Administrator on the PC (elevated prompt on Vista).
Run net stop CryptSvc.
Run esentutl /p %systemroot%\System32\catroot2\{F750E6C3-38EE-11D1-85E5-00C04FC295EE}\catdb.
When prompted, choose OK to attempt the repair.
Exit the command prompt.
Reboot.
CSCsm54689 Bug Details
| Anyconnect, non-informative error with routing and remote access service |
Symptom:
When RRAS enabled on the windows PC anyconnect will fail will error message "The VPN client driver has encountered an error." Although anyconnect will not function with Routing and remote access service on, the error is misleading and should be more informative to tell the customer what the actual problem encountered was.
Conditions:
Routing and Remote Access Service enabled in windows
Workaround:
make sure Routing and Remote Access Service is disabled before starting anyconnect.
Further Problem Description:
none
|
Regards
Jorge Rodriguez
