06-11-2010 07:36 AM - edited 03-19-2019 01:04 AM
Hello,
I need to explain to my customer interoperability between CUCM and Apple iPhone, Nokia E52, SIP Third-party device ...
I configured "Dual-mode phone for iPhone" device in my CUCM company, and it works very well!
I installed a new DEMO CUCM, but "Dual-mode phone for iPhone" device doesn't work! When I try to connect my iPhone to new DEMO CUCM, device gives me this error: "Failed to register with the supplied information".
In the new DEMO CUCM, i have only configure Device Pool, Partition, CSS ... below, in attach, you can find my "Dual-mode phone for iPhone" device on new DEMO CUCM configuration.
Any ideas?
Thank you!
Solved! Go to Solution.
06-11-2010 02:33 PM
Go to CUCM > System > Servers.
Are you using hostname or IP address there? If your iPhone cannot resolve the hostname there, you should change the hostname to IP address (on CUCM).
Michael
06-11-2010 02:33 PM
Go to CUCM > System > Servers.
Are you using hostname or IP address there? If your iPhone cannot resolve the hostname there, you should change the hostname to IP address (on CUCM).
Michael
06-14-2010 12:03 AM
OK,
it works!
Thank you!
11-26-2010 12:50 PM
This was driving me a little nuts in our test lab ... no FQDN on the CUCM service, changed to IP - works fine.
Thanks...
08-01-2011 12:52 AM
Do I need a lincence this services, Ih we need a licence how can add licence the system,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: