2924 port security sticky

Unanswered Question
Jun 12th, 2010
User Badges:

ok im trying to set my FastEth port 3 into sticky security, but when i go to enter commands this is what i get:

BasementSwitch#config t
Enter configuration commands, one per line.  End with CNTL/Z.
BasementSwitch(config)#int fa0/3
BasementSwitch(config-if)#switchport access?
  access    Set access mode characteristics of the interface
  mode      Set trunking mode of the interface
  multi     Set characteristics when in multi-VLAN mode
  priority  Set 802.1p priorities
  trunk     Set trunking characteristics of the interface
  voice     Voice appliance attributes
BasementSwitch(config-if)#switchport access vlan 1
BasementSwitch(config-if)#switchport port-security ?
% Unrecognized command

can someone help me with this, thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Reza Sharifi Sat, 06/12/2010 - 18:15
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

This is what you should see after ?

Management-Switch(config-if)#switchport port-security ?
  aging        Port-security aging commands
  mac-address  Secure mac address
  maximum      Max secure addresses
  violation    Security violation mode

Management-Switch(config-if)#switchport port-security

maybe port securiy in not supported

nate faulds Sat, 06/12/2010 - 18:18
User Badges:

yea w

hen i boot it says i downloaded the LRE image, im downloading the non  LRE and hopefully that will help

Reza Sharifi Sat, 06/12/2010 - 18:41
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

be careful

LRE image may not work on a regular 2924

nate faulds Sat, 06/12/2010 - 18:50
User Badges:

yea i just nopticed at boot it says that my 2924XL isnt LRE compatable, so i am re uploading a non LRE


This Discussion

Related Content