cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1441
Views
0
Helpful
4
Replies

2924 port security sticky

nate faulds
Level 1
Level 1

ok im trying to set my FastEth port 3 into sticky security, but when i go to enter commands this is what i get:

BasementSwitch>en
Password:
BasementSwitch#config t
Enter configuration commands, one per line.  End with CNTL/Z.
BasementSwitch(config)#int fa0/3
BasementSwitch(config-if)#switchport access?
  access    Set access mode characteristics of the interface
  mode      Set trunking mode of the interface
  multi     Set characteristics when in multi-VLAN mode
  priority  Set 802.1p priorities
  trunk     Set trunking characteristics of the interface
  voice     Voice appliance attributes
BasementSwitch(config-if)#switchport access vlan 1
BasementSwitch(config-if)#switchport port-security ?
% Unrecognized command

can someone help me with this, thanks.

4 Replies 4

Reza Sharifi
Hall of Fame
Hall of Fame

This is what you should see after ?

Management-Switch(config-if)#switchport port-security ?
  aging        Port-security aging commands
  mac-address  Secure mac address
  maximum      Max secure addresses
  violation    Security violation mode
 

Management-Switch(config-if)#switchport port-security

maybe port securiy in not supported

yea w

hen i boot it says i downloaded the LRE image, im downloading the non  LRE and hopefully that will help

be careful

LRE image may not work on a regular 2924

yea i just nopticed at boot it says that my 2924XL isnt LRE compatable, so i am re uploading a non LRE

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco