cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2178
Views
0
Helpful
2
Replies

Combination ports in Cisco 4948

kashif.rizvi
Level 1
Level 1

Hello all,

I would like to know if there is any config required to enable last 8 combination ports of Cisco 4948 Switch.

I dont have a requirement for GBIC and would like to use ports from Gi1/45 to 48 thru regukar RJ45 but they are showing down.

Seems like it is currently set for GBIC. Below is the interface status output for the ports:

Gi1/45                       notconnect   705          full   1000 No Gbic
Gi1/46                       notconnect   1            full   1000 No Gbic
Gi1/47                       notconnect   1            full   1000 No Gbic
Gi1/48                       notconnect   1            full   1000 No Gbic

Kindly advice if there is any way to activate the Gigabit RJ45 ports?

1 Accepted Solution

Accepted Solutions

Jon Marshall
Hall of Fame
Hall of Fame

kashif.rizvi wrote:

Hello all,

I would like to know if there is any config required to enable last 8 combination ports of Cisco 4948 Switch.

I dont have a requirement for GBIC and would like to use ports from Gi1/45 to 48 thru regukar RJ45 but they are showing down.

Seems like it is currently set for GBIC. Below is the interface status output for the ports:

Gi1/45                       notconnect   705          full   1000 No Gbic
Gi1/46                       notconnect   1            full   1000 No Gbic
Gi1/47                       notconnect   1            full   1000 No Gbic
Gi1/48                       notconnect   1            full   1000 No Gbic

Kindly advice if there is any way to activate the Gigabit RJ45 ports?

4948(config)# int range gi1/45 - 48

4948(config-if-range)# media-type rj45

Jon

View solution in original post

2 Replies 2

Jon Marshall
Hall of Fame
Hall of Fame

kashif.rizvi wrote:

Hello all,

I would like to know if there is any config required to enable last 8 combination ports of Cisco 4948 Switch.

I dont have a requirement for GBIC and would like to use ports from Gi1/45 to 48 thru regukar RJ45 but they are showing down.

Seems like it is currently set for GBIC. Below is the interface status output for the ports:

Gi1/45                       notconnect   705          full   1000 No Gbic
Gi1/46                       notconnect   1            full   1000 No Gbic
Gi1/47                       notconnect   1            full   1000 No Gbic
Gi1/48                       notconnect   1            full   1000 No Gbic

Kindly advice if there is any way to activate the Gigabit RJ45 ports?

4948(config)# int range gi1/45 - 48

4948(config-if-range)# media-type rj45

Jon

Thanks Jon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: