06-15-2010 06:03 AM - edited 03-10-2019 05:11 PM
Hi,
We are have two syslog servers defined, however we notice that the ACS only sends the syslogs to one server and will only send to the other in a failure scenario, which is a standard operation across all platforms. However we have a requirement for the ACS to send syslogs to both servers simultaneously, is there a configuration option for this?
Many Thanks
Leon Noble
06-23-2010 11:33 AM
hi
what version of ACS you are using? ACS 5.0 and 5.1 can support 2 syslog server simultaneously .
regards,
06-24-2010 12:15 AM
Thanks,
We are 5.1, but are unable to find the setting that allows this, can you help.
Many Thanks
06-24-2010 12:50 AM
You can do the following:
1) Create a remote log target for your syslog server atSystem Administration > Configuration > Log Configuration > Remote Log Targets
2) Configure the log categories that should be enabled to eb sent to this log target.
Go toSystem Administration > Configuration > Log Configuration > Logging Categories > Global
Select a specifc category and then look at "Remote Syslog Target" tab.
For each category that you want sent to your syslog server select the remote log target in the "
06-25-2010 03:00 AM
Thanks,
That has worked perfectly, thanks again for the help.
06-28-2010 04:18 PM
Hi
I am not sure if there is an option but what is the ACS version you are talking about ?
Thanks
Waris Hussain
06-29-2010 12:41 AM
Hi Waris,
Not sure if you have seen the post from jrabinow, but the solution that was provided by jrabinow works for our requirement. It is version 5.1
Kind Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: