Local Network Address Change

Unanswered Question
Jun 15th, 2010

I have a WRV210 router. I can see it and configure it either manually or through the setup program. If I change the router address from to and reboot both the router and my computer I can access the internet, ipconfig says that is my gateway, but I cannot log on to the router at The MS PD tool says that the connection was rejected by the target. Reset router more than once with the same result.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Rajdeep Parmar Wed, 06/16/2010 - 12:34

nothing u have to add that ip renge in your network.

how ????

open local area network -- properites - - TCP /IP -- Select properties again ..

it will open a new window.. where  u can config ur ip address manually & DCHP ...

select use the following ip add . ( ur subnet mas k) ( GW ) ( DNS)

then  bottom of the page u can see one advance button click on that one  put any ip addres of that range .. like ..192.168.3 .240

save it n reboot ur router ...

n now try to open in web page....


Rajdeep P .


This Discussion