06-16-2010 08:19 AM - edited 03-06-2019 11:36 AM
Hello,
When I'm on our main router I might need to telnet to a number of routers from that during that session, rather than me typing "telnet 192.168.1.1" etc etc is there a way I can craete a short cut so I might just type "r1" for router 1 and it telnets to the router? I guess I could use the "ip host" option.
Solved! Go to Solution.
06-16-2010 08:28 AM
You could create this alias
config t
alias exec r1 telnet 192.168.1.1
that should work.
Mike
06-16-2010 08:28 AM
You could create this alias
config t
alias exec r1 telnet 192.168.1.1
that should work.
Mike
06-16-2010 08:37 AM
Hello,
When I'm on our main router I might need to telnet to a number of routers from that during that session, rather than me typing "telnet 192.168.1.1" etc etc is there a way I can craete a short cut so I might just type "r1" for router 1 and it telnets to the router? I guess I could use the "ip host" option.
Hi,
To define a static host name-to-address mapping in the host cache, use the ip host global configuration command. To remove the name-to-address mapping, use the no form of this command.
ip host name [tcp-port-number] address1 [address2...address8]
Config# ip host ROUTER_NAME INT_Address
Example: ip host lab-a 192.168.5.1
or Config# ip host RTR_NAME INT_ADD1 INT_ADD2 INT_ADD3
Example: ip host lab-a 192.168.5.1 205.23.4.2 199.2.3.2 - (for e0, s0, s1)
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: