ATA 186 with non-Cisco Switches

Unanswered Question
Jun 16th, 2010
User Badges:

Dear Experts,

I have Cisco ATA 186 was connected to Cisco Switches and was working fine getting IP from DHCP from the CUCM 6 but I just migrated to Juniper Switches and ATA doesn't get IP through the new Switches.

I assigned the IP Address manually through IVR but I think I have to set the new VLAN also but I do not know How I do because it doesnot work via the new switches

Any help?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
CHRIS CHARLEBOIS Wed, 06/16/2010 - 12:41
User Badges:
  • Silver, 250 points or more

Did you configure the ATA's initially?  I would assume that they would work with any switch.  However, perhaps them were setup on a particular VLAN and are expecting to receive an IP address on a dot1q tagged vlan.

Actions

This Discussion